Terms of Use

Last updated 12 September 2026

Mic Bleed Remover is an audio repair tool for iPhone and iPad, published by Bulpara Teknoloji Limited Şirketi. These terms cover what it does, what the subscription includes, and what it does not promise. By using the App you agree to them.

1. What the App does

Mic Bleed Remover takes the two microphone tracks from a two-person recording — two separate files, or one dual-channel file with a speaker on each channel — lines them up, corrects the drift between two independent clocks, and subtracts each voice from the other’s track. It uses the opposite recording as its reference, so the interfering signal is one it has been given rather than one it has estimated. All of it happens on your device, without a network connection.

2. What the App is not

It is a repair tool for one specific defect: the same conversation appearing on both microphones. It is not a general noise reducer, it does not remove hiss, hum, rumble or room tone, and it is not a transcription or editing suite.

It is not surgical separation, and it does not claim to be. What it aims at is bringing the other voice far enough down that each track can be gated, levelled and edited on its own. Stretches where both people talk at once are the hard case for any canceller of this kind.

This is why the App measures your recording and shows you that figure, on the worst moment it can find in your own session, before you are asked for anything.

3. Free and Premium

The App is free to download and use. The free tier is limited by the file, not by the result. There is no length cap: you can import recordings of any length, as many as you like, and hear the whole cleaned result at full quality, including the measured figure from your own session.

What the free tier includes is one full export — both tracks, at full length, never watermarked — plus the built-in sample session, which is unmetered. Exports after that need Premium.

Premium adds unlimited exports of every session at full length on both tracks, WAV 24-bit export, and the Light and Strong strength settings alongside Standard.

4. Subscription terms

The free export is counted on your device and deliberately survives deleting and reinstalling the App — see section 3 of the privacy policy, which describes exactly what is stored and where.

5. Acceptable use

Use the App lawfully, and only on recordings you have the right to edit — which, in a two-person recording, means both people’s tracks. Do not use it to alter an authenticated recording in order to misrepresent what was said, and do not attempt to work around the free tier’s limits or to reverse engineer the App.

6. Your recordings are yours

You keep every right you had in anything you import. The App claims no licence over it, and could not exercise one in any case: your audio never leaves your device. See the privacy policy.

7. Our side

The App, its design and its code belong to Bulpara Teknoloji Limited Şirketi. You get a limited, non-exclusive, non-transferable licence to use it for its intended purpose.

8. What the App does not promise

The App is provided as it is. Recordings vary enormously — the room, the spacing between the microphones, the gear, and how much the two people talk over each other all change what is achievable — and no processing can guarantee a particular result on a particular recording.

Any measurements published on this site were taken on a fixed set of synthetic test recordings, described where they appear. They are evidence about the method, not a prediction about your files. The figure that applies to your recording is the one the App measures on your recording and shows you.

Keep your originals. The App writes new files and never modifies what you imported, but no software should be the only copy of anything you care about.

To the extent the law allows, Bulpara is not liable for lost recordings, lost work, or other indirect losses arising from using the App. Nothing here limits liability that cannot lawfully be limited.

9. Changes

These terms may change as the App changes. The date at the top says when they last did.

10. Contact

support@bulpara.com, or through Support.